Zündschlüsselsatz Boss 302

[Boss-Driver]

Hi there
Weiss jemand wie viele Schlüssel bei der Ablieferung vorhanden waren. Ich habe das Pferdchen von 1. Hand gekauft und zwei Schlüssel erhalten (1 normaler plus der Track Key). Nun habe ich erfahren, dass ursprünglich 2 Schlüssel und der Track Key geliefert wurden.

Was ist denn nun Sache?

Beste Grüsse

[buland]

Es waren immer 2 Schlüssel. Silber und Rot.
Ich empfehle dir einen 3. zu besorgen und diesen zu programmieren. So kannst du dir den weg zum Händler für die programmierung sparen wenn du nur noch einen hast.

zb diesen:
http://www.ebay.com/itm/NEW-Ford-Mustan ... Gf&vxp=mtr

dann zu einem guten schlüsseldienst schleifen gehen und selber programmieren.

[Boss-Driver]

Hoi Buland

Danke für deine Antwort. Wie kann ich den selbst programmieren? Gibt’s hierfür eine Anleitung?

Beste Grüsse

[buland]

In der Bedienungsanleitung ab Seite 70 ist der Vorgang genau beschrieben.

Programming a Spare Key
Note: A maximum of eight coded keys can be programmed to your
vehicle. Only four of these eight can be integrated keyhead transmitters.
You can program your own integrated keyhead transmitters or standard
SecuriLock coded keys to your vehicle. This procedure will program both
the engine immobilizer key code and the remote entry portion of the
remote control to your vehicle.
Only use integrated keyhead transmitters or standard SecuriLock keys.
You must have two previously programmed coded keys and the new
unprogrammed key readily accessible. See your authorized dealer to have
the spare key programmed if two previously programmed coded keys are
not available.
Read and understand the entire procedure before you begin.
1. Insert the first previously programmed coded key into the ignition.
2. Turn the ignition from off to on. Keep the ignition on for at least three
seconds, but no more than 10 seconds.
3. Turn the ignition off and remove the first coded key from the ignition.
4. After three seconds but within 10 seconds of turning the ignition off,
insert the second previously coded key into the ignition.
5. Turn the ignition from off to on. Keep the ignition on for at least three
seconds, but no more than 10 seconds.
6. Turn the ignition off and remove the second previously programmed
coded key from the ignition.
7. After three seconds but within 20 seconds of turning the ignition off
and removing the previously programmed coded key, insert the new
unprogrammed key into the ignition.
8. Turn the ignition from off to on. Keep the ignition on for at least six
seconds.
9. Remove the newly programmed coded key from the ignition.
The key will start the vehicle’s engine and will operate the remote entry
system (if the new key is an integrated keyhead transmitter) if it has
been successfully programmed. The theft indicator light will illuminate
for three seconds and then go out to indicate successful programming.
If the key was not successfully programmed, the theft indicator light may
flash on and off. Wait 20 seconds and repeat Steps 1 through 8. Take
your vehicle to your authorized dealer to have the new key programmed
if you are still unsuccessful.
Wait 20 seconds and then repeat this procedure from Step 1 to program
an additional key.

[Boss-Driver]

Danke Dir!

Da bin ja mal gespannt ob ich das hinkriege.

Beste Grüsse

[buland]

Sonst einfach melden. Du bist ja nicht sooo weit weg